Home› Troubleshooting

Discussion

Left ArrowBack to discussions page
steinstein Posts: 1 Recruit
in Troubleshooting
I have a Fanuc LR Mate 200IC with a conversion board for CRMA 58 & 59 50 pin plugs. I am able to get DO from plug 58 but I cannot get and out put from plug 59. Any suggestions?
· TwitterFacebook

Comments

  • Tim_SmithTim_Smith Posts: 38 Apprentice
    edited February 2017
    @stein Are you looking to configure the the DI/DO or the RI/RO? I am not very familiar with Fanuc, but I think there is difference when setting up these pins.
    · TwitterFacebook
Sign In or Register to comment.
Left ArrowBack to discussions page