
Home› Robotiq Products
Discussion
Back to discussions page
Etienne_Samson
Beta Tester Beetle, Wrist Camera URCap 1.3.0, Vacuum Beta tester Posts: 419 Handy
For in depth stuff consult the Robotiq User Interface manual and check this blog bost by @mathbelanger.
How and Why you should use the Robotiq User Interface (RUI) |
558 views
|
Not answered yet | |
/ Started by Unknown |
0 comments |

This how-to is intended for Robotiq Grippers (all version, any Gripper)For Sensor software, see the post on the demo software for FT Sensor.
For in depth stuff consult the Robotiq User Interface manual and check this blog bost by @mathbelanger.
Why use the Robotiq User Interface ?
- Configuration
- Testing
- Demos
- Troubleshooting
How ?
- Visit support.robotiq.com, check the RUI section, download the installer.
- Unzip and install on your PC
- Power your Robotiq device with 24 V, wire the USB, plug into your PC
- Execute the Robotiq User Interface
- From the connect screen, select the appropriate COM port or click "auto-connect" if you have a single device
- Once connected, you can activate your Gripper, run demo, troubleshoot, configure communication, etc.
Etienne Samson
Technical Support Director
+1 418-380-2788 ext. 207
[email protected]
[email protected]
Tagged: