Home› Robotiq Products
Discussion
Back to discussions page
yshen
Posts: 2 Recruit
FT 300 Sensor Calibration w/o a Robotic Arm (Jetson NX + Ubuntu + ROS) |
12 views
|
Not answered yet | |
/ Started by Unknown |
0 comments |

Dear DoF Pros,
Hi, I have a FT 300 sensor (2019) and running a ros-industrial/robotiq ROS package (http://wiki.ros.org/robotiq, https://github.com/ros-industrial/robotiq) in the following environment:
Please note that there is no robotic arm in this application, the orientation/position of the sensor is fixed (45 deg tilted), and I attached a short handle to the sensor. The goal is to measure the force/torque added to the handle.
Question: is there is a way to calibrate the sensor in such no-robotic-arm settings? Or, do I need to?
Any information/suggestion/instruction would be much appreciated.
Best regards,
AS
Hi, I have a FT 300 sensor (2019) and running a ros-industrial/robotiq ROS package (http://wiki.ros.org/robotiq, https://github.com/ros-industrial/robotiq) in the following environment:
- Jetson Xavier NX
- Ubuntu 18.04 LTS
- ROS Melodic
Please note that there is no robotic arm in this application, the orientation/position of the sensor is fixed (45 deg tilted), and I attached a short handle to the sensor. The goal is to measure the force/torque added to the handle.
Question: is there is a way to calibrate the sensor in such no-robotic-arm settings? Or, do I need to?
Any information/suggestion/instruction would be much appreciated.
Best regards,
AS