Error of "40 is outside of the acceptable address range"

The Dof Community was shut down in June 2023. This is a read-only archive.
If you have questions about Robotiq products please reach our support team.

Categories Discussions

Home > Robotiq Products > Error of "40 is outside of the acceptable address range"

Yeji 2020-12-21

Hi, everyone. I am a new user of Robotiq FT-300, nowadays I install the Ft-300 force sensor in my CB-series UR5 robot and want to demonstrate some pin inserting process.
But the error of "40 is outside of the acceptable address range" was always shown in the robot controller, I cannot find any solution on the internet and it has already confused me for a long time.

I am really looking for your replyment.

Thank you!

bcastets 2020-12-21

I open a support ticket to follow this issue.