PaulGWF
Hello Enric!
Have you tried to zero the sensor before doing the calibration?
Regards.
Paul
The Dof Community was shut down in June 2023. This is a read-only archive.
If you have questions about Robotiq products please reach our support team.
If you have questions about Robotiq products please reach our support team.
Hi,
I currently have 2 FT300 with two UR10 with the same end-effector. I have differences of up to 1kg if i change only the sensor in the calibration process.
I do proces calibrate with 1 sensor and I have a weight of 4.7kg and if I put the other sensor I have 3.8kg.
Where do I have the error?
Enric