DoF - a Robotiq Community
Warning sign
The Dof Community was shut down in June 2023. This is a read-only archive.
If you have questions about Robotiq products please reach our support team.
Categories Discussions
Home > Programming > How can use Labview to program to control the Robotiq 3-finger gripper
jasonlau

Hello!
I just only have Robotiq 3-finger gripper, how can use Labview 2013 to program to control the gripper?
Have some program library could be use?
Thanks!
MarcAntoine_Gauthier

Hello,

We unfortunately don't have any examples or procedure to use our products on Labview. You can refer to this DoF Post to help you out. In all cases, you will have to open a ModBus communication and send command as explained in the manual in Section 4.7.

See links below:
https://assets.robotiq.com/website-assets/support_documents/document/online/HTML5_20190322.zip/HTML5/Default.htm#3-Finger-Instructions-Manual-06-2017/4.%20Control.htm%3FTocPath%3D_____4

https://dof.robotiq.com/discussion/comment/3501#Comment_3501

Regards.