DoF - a Robotiq Community
Warning sign
The Dof Community was shut down in June 2023. This is a read-only archive.
If you have questions about Robotiq products please reach our support team.
Categories Discussions
Home > Programming > Seeking for the part using a different snap position
Fabricator89

I am trying to get closer to my part so I can scan it as an inspection cycle to verify all features were put on the part. Can this be done?
*The initial snap position is to far away. (Had to bring it up to see the grid)
Nicholas_Francoeur

Hi @Fabricator89,

See this post explaining that the snapshot position can be different than the calibration position. 

Note that it is also possible to use a Camera Locate that is relative to another Camera Locate. Let me know if you need help with this.