David_Levasseur
Hello @xuwei, this is a strange behavior indeed. Glad to hear you found a workaround though. If it ever happens again, please send pictures and serial number to support@robotiq.com
The Dof Community was shut down in June 2023. This is a read-only archive.
If you have questions about Robotiq products please reach our support team.
If you have questions about Robotiq products please reach our support team.
I found a question abot FT300.Sometimes his F's data was the 320N and R's 30N.m ,if i set zero it all was zero without changing data and i can not connect his 63351 port.At this time i did calibration many times ,then Ft300 was good and i can connect 63351 port.