Home› Integration
Discussion
Back to discussions page
imuguruza
Posts: 5 Apprentice
2 Finger Gripper - Question about communication logic |
188 views
|
Answered | |
/ Most recent by Guillaume_Charron
in Integration
|
4 comments |

Hi there,
I'm trying to communicate using a RS-485 breakout with the gripper.
As I was having little success, I have checked further what was going on. I have realized that the breakout I'm using generates voltage in 0-3v3 range.
I was wondering if the gripper will understand it or I need to generate 0-5V level RS-485 signal.
Thanks in advance,
imuguruza
I'm trying to communicate using a RS-485 breakout with the gripper.
As I was having little success, I have checked further what was going on. I have realized that the breakout I'm using generates voltage in 0-3v3 range.
I was wondering if the gripper will understand it or I need to generate 0-5V level RS-485 signal.
Thanks in advance,
imuguruza
Tagged:
I will have a look into the datasheet.
imuguruza
I was wondering if it's possible changing my 2-Finger Gripper protocol, from RS-485 to RS-232
Thanks again,
imuguruza
Robotiq does sell an RS485-RS232 converter, the part number is ACC-ADT-RS232-RS485. You can send a buying request to [email protected]
Support Tech
+01 418-380-2788 ext. 236
[email protected]