Home Troubleshooting

Discussion

Left ArrowBack to discussions page
Grady_TurnerGrady_Turner Founding Pro, Partner, Beta Tester VIsion 1.1 Program, Wrist Camera URCap 1.3.0 Posts: 67 Handy
edited August 2016 in Troubleshooting
Is anyone having an issue getting the camera calibrated?

Every time the calibration process stops before taking the 18 calibration poses.  I have tried different backgrounds and different starting positions (making sure to update the "snapshot pose" feature).  When I press "calibrate," the robot moves to a few locations taking pictures (differs in number depending on where I start relative to the board) and then for a few seconds the picture area on the left shows the Poses 1-9 grid.  After that the camera begins flashing on and off and the "Calibrate" button is available again.

I know in the training something that was discussed was having error messages, or failure notices since those are not explicit.

Any advice, thoughts?  I may be missing something very simple.

Comments

Sign In or Register to comment.
Left ArrowBack to discussions page