Discussion

Left ArrowBack to discussions page
Hi Pros,

I was wondering if you get singularities or collision during the automatic scan, how do you work your way around this? What are the tips and tricks to avoid this?
Tagged:

Comments

  • Etienne_SamsonEtienne_Samson Posts: 416Beta Tester Beetle, Wrist Camera URCap 1.3.0, Vacuum Beta tester Handy
    @Sebastien is this question about the scanning when teaching an object to the Robotiq vision system using Wrist Camera ?
    Etienne Samson
    Technical Support Director
    +1 418-380-2788 ext. 207
    [email protected]
  • SebastienSebastien Posts: 219 Handy
    Yes exactly @Etienne_Samson
  • Etienne_SamsonEtienne_Samson Posts: 416Beta Tester Beetle, Wrist Camera URCap 1.3.0, Vacuum Beta tester Handy
    Alright @Sebastien, for singularities (out of reach or too close to base) the software checks for those before you start scanning, so if you try to scan with a part out of reach, you will get a pop-up that says "some scan poses are unreachable" and will ask you to move the part and try again.

    For collision with the environment we got nothing embedded and it's the operator's duty to watch the robot. If anyone got any hints on that it would be great !
    Etienne Samson
    Technical Support Director
    +1 418-380-2788 ext. 207
    [email protected]
  • SebastienSebastien Posts: 219 Handy
    @Etienne_Samson
    Sounds good. If we run into a collision issue we will keep you posted!

Sign In or Register to comment.
Left ArrowBack to discussions page